Install Upgraded Rear View Mirror on Polaris Ranger 2017-2025

Quick answer

Install an upgraded rear view mirror on your Polaris Ranger (2017-2025) by removing the factory mirror, mounting the new bracket, adjusting the ball joint, and tightening the sliding height adjustment. The whole job takes about 15 minutes with basic hand tools.

Installation steps

1. Remove the factory mirror: Locate the factory mirror mount on your Polaris Ranger's roll cage or windshield frame. Use a Torx or hex driver (commonly T25 or 5mm) to remove the mounting screws. Gently pull the mirror off the mount. Keep the original hardware in case you need it later. Common mistake: Forcing the mirror off without loosening all screws can crack the housing.
2. Attach the upgraded mirror bracket: Position the KEMIMOTO upgraded mirror bracket over the same mounting holes. Insert the supplied screws and hand-tighten them. Use a driver to snug them evenly—do not overtighten, as the bracket is designed to clamp securely without distorting the frame. Checkpoint: Verify the bracket sits flat against the cage before tightening fully.
3. Adjust the mirror height: Loosen the two screws on the sliding mount. Slide the mirror assembly up or down until the center of the mirror is at eye level when you're seated. Tighten the screws to lock the height. The sliding design allows this step to be repeated without disassembling the mount. Common mistake: Setting the height too high or low reduces rear visibility—adjust while sitting in the driver's seat.
4. Set the ball-joint angle: Grasp the mirror head and pivot it at the ball joint to aim the glass toward the rear of the vehicle. The ball joint provides a wide range of tilt and rotation, so you can eliminate blind spots on both sides. Tighten the ball-joint lock nut if your model includes one. Checkpoint: Have a helper stand behind the vehicle while you adjust to confirm the mirror covers the full rear width.
5. Final tighten and test ride: Go over all screws and the ball-joint lock nut with the appropriate driver. Give the mirror a firm shake to ensure it won't vibrate loose. Take a short test ride over rough terrain, then re-check tightness. If the mirror shifts, re-tighten and consider thread-locker on the bracket screws. Common mistake: Skipping the test ride can lead to a loose mirror that shifts during trail use.

What you need

• Upgraded Rear View Mirror for Polaris Ranger 500 570 900 XP 1000 XP/Crew 2017-2025: The upgraded mount features a sliding design for easy height adjustments without disassembly. Simply loosen the screws, slide the mirror to your desired height, and tighten them. This lets you fine-tune mirror placement quickly, even when switching between drivers or carrying different loads.