Mount a Whip Light on a Pro-Fit Cage in 6 Steps
By Kemimoto Official: Aftermarket UTV Accessories & Parts | Published: 2026-10-29
Category: How-to Guides
Learn how to install a whip light flag on a Pro-Fit roll cage, including mounting tips and common mistakes to avoid for a secure fit.
Quick Answer
Mount a whip light flag on a Pro-Fit cage by selecting a flat, accessible roll bar section, securing the clamp with supplied hardware, and routing the wire neatly. Use a durable mount like the Kemimoto UTV flag mount for a corrosion-resistant fit.
Why the Pro-Fit Cage Needs Special Attention
Pro-Fit cages often have curved or uneven bars that can make a standard whip light mount slip. You need a clamp with a 360-degree rotation feature to adjust the flag angle without loosening the grip.
Installation Steps
- Choose the Mounting Spot: Pick a flat, straight section of the Pro-Fit roll bar near the rear of the cage. Avoid areas where the bar curves sharply, as the clamp won't sit flush. A curved spot can cause the mount to loosen over time.
- Disassemble the Clamp: Remove the two halves of the mount clamp. Place the back half behind the roll bar and the front half over it. Align the holes for the bolts. Ensure the clamp's rubber padding is facing the bar to prevent scratching.
- Tighten the Bolts Evenly: Hand-thread both bolts, then tighten them alternately with a wrench. Stop when the clamp is snug against the bar—do not overtighten, as aluminum can strip. Overtightening can warp the clamp or damage the roll bar coating.
- Attach the Whip Light Base: Slide the whip light flag into the mount's receiver and secure it with the set screw. Adjust the flag to a vertical position before locking it. If the flag leans, loosen the 360-degree rotation nut and reposition it.
- Route the Power Wire: Run the wire from the whip light along the roll bar, using zip ties every 6-8 inches. Keep the wire away from moving parts like seats or doors. Loose wires can snag on branches or get pinched in the cage.
- Test the Light and Angle: Turn on the whip light to confirm it works. Adjust the flag angle so it points straight up and doesn't hit the cage or roof when the vehicle bounces. A misaligned flag can rub against the cage and wear out the light wire.
Product Used in This Guide
- UTV Whip Light Flag Mount for Pro-fit Cage: Made of premium aluminum with CNC cutting, scratch-resistant, dustproof, and corrosion-resistant. This ensures the mount stays secure and looks good even after repeated off-road use and weather exposure.
UTV Whip Light Flag Mount for Pro-fit Cage
