Can-Am Outlander MAX Passenger Rear Seat Installation Guide
By Kemimoto Official: Aftermarket UTV Accessories & Parts | Published: 2026-10-25
Category: How-to Guides
Learn how to install the Can-Am Outlander MAX passenger rear seat with armrests on 2012–2024 models. Follow these step-by-step instructions for a secure fit and common pitfalls to avoid.
Quick answer
Install the Can-Am Outlander MAX passenger rear seat by first removing the cargo box, mounting the seat bracket, then attaching the seat and armrests. This guide covers 2012–2024 models and highlights common mistakes to avoid.
Before you start: Check your model year and hardware
This installation is designed for Can-Am Outlander MAX models from 2012 through 2024. The seat uses the existing mounting points on the rear cargo area, but the included bracket may need slight adjustment if your machine has aftermarket accessories. Have a T-handle torx set and a 10mm socket ready. The seat is built with heavy-duty PVC leather and sponge padding, so it's weather-resistant and comfortable for passengers on long rides.
What to watch for during installation
The most common mistake is overtightening the bracket bolts, which can strip the threads in the aluminum frame. Another is forgetting to route the seat belt webbing before fully securing the seat. Take your time aligning the bracket; a crooked mount will make the armrests misalign and cause rattling.
Installation steps
- Remove the rear cargo box: Unclip the cargo box by releasing the latches at the rear corners. Lift it straight up and set it aside. You'll see four threaded holes on the frame rails—these are your mounting points. If the box is stuck, check for a hidden latch or a tie-down strap you forgot to remove.
- Mount the seat bracket: Position the steel bracket over the frame holes. Insert the four bolts and hand-tighten them. Use a torque wrench to tighten to 15 ft-lb—do not exceed this, as the aluminum threads can strip. Apply a drop of thread locker to each bolt to prevent loosening from vibration.
- Attach the seat base: Slide the seat base onto the bracket tabs until you hear it click. Push down firmly on both sides to ensure full engagement. The seat should not rock or shift. If it doesn't click, the bracket may be misaligned. Loosen the bracket bolts and shift it slightly.
- Install the armrests: Insert each armrest into the socket on the seat base. Push down until the locking pin snaps into place. Test by pulling upward—the armrest should not come out. The armrests are handed (left and right). Check the orientation before pushing; forcing the wrong side can break the locking tab.
- Route and secure the seat belt: Pull the seat belt webbing through the slot in the seat base. Click the buckle into the receiver and adjust the strap so it lies flat. Verify the belt retracts smoothly when unbuckled. Twisted webbing will cause the belt to jam. Straighten it before the final buckle click.
- Final check and test ride: Sit on the seat with a passenger to check for stability. Wiggle the seat and armrests—any movement means a bracket bolt is loose. Take a short ride on rough terrain and recheck all fasteners. Re-torque the bracket bolts after the first 50 miles, as new rubber grommets can settle.
Product details
- Can-Am Outlander MAX Passenger Rear Seat with Armrest (2012–2024): Made from premium PVC leather with sponge padding, wrinkle-free, wear-resistant, and water-resistant. The seat withstands mud, rain, and UV exposure without degrading, so you don't need to store it indoors after every ride.
Can-Am Outlander MAX Passenger Rear Seat with Armrest (2012–2024)
