How to Install a 50-Inch RGB Light Bar on Can-Am Maverick X3
By Kemimoto Official: Aftermarket UTV Accessories & Parts | Published: 2026-10-23
Category: How-to Guides
Learn step-by-step how to install a 50-inch RGB light bar on your Can-Am Maverick X3. Includes wiring tips, mounting advice, and common mistakes to avoid for a clean off-road lighting setup.
Quick Answer
Mount the light bar to the front bumper or roof crossbar, route the wiring harness to the battery, and connect the control switch inside the cab. Pay extra attention to the rocker switch wiring to avoid short circuits.
Why Choose a 50-Inch RGB Light Bar for Your Maverick X3
A 50-inch RGB light bar adds both functional illumination and customizable style to your Can-Am Maverick X3. The combination of a 6° spot beam and 60° flood beam provides long-distance focus and wide, even lighting for safer night riding. The RGB ambient modes let you match the look of your UTV for shows or trail rides.
The Kemimoto 50" 390W RGB LED Light Bar (compatible with 2017–2026 models) delivers up to 15,500 lumens and includes 8 lighting modes—one white driving light plus seven ambient colors. It uses a rocker switch for easy mode changes, but the wiring requires careful planning to keep the cab tidy and the connections weatherproof.
Tools and Prep Work
Before starting, gather: a socket set (10mm and 13mm common), wire strippers, crimp connectors, heat shrink tubing, zip ties, a multimeter, and a drill with a step bit if you need to create a switch mounting hole. Disconnect the negative battery terminal to prevent shorts.
Plan the routing path: from the light bar down the front cage, under the hood, through the firewall grommet, and to the battery. Leave slack at the light bar end so you can adjust the angle.
Installation Steps
- Mount the Light Bar: Attach the light bar to the front bumper or roof crossbar using the supplied brackets. Center it and tighten bolts to the spec in the manual. A common mistake is overtightening, which can crack the housing. Check the bracket alignment before tightening fully.
- Route the Wiring Harness: Run the main harness from the light bar along the cage, using zip ties every 6–8 inches. Keep it away from hot or moving parts. Pass the harness through the firewall grommet into the cab. Use a wire coat hanger to fish the harness through the grommet without damaging it.
- Connect the Rocker Switch: Mount the rocker switch in a convenient dash location. Connect the switch wires to the harness: typically red to power, black to ground, and the remaining wire to the light bar control. Use a multimeter to verify polarity. A common mistake is reversing the switch wires, causing the light to stay on or not respond.
- Wire to the Battery: Connect the red wire to the battery positive terminal and the black wire to the negative terminal. Insert the included fuse holder within 6 inches of the battery. Test the light bar before securing all wires. Always install the fuse close to the battery to protect the circuit from shorts.
- Secure and Test All Connections: Tuck any excess wire and secure it with zip ties. Turn on the light bar and cycle through all 8 modes to confirm each works. Check that the switch LED and ambient colors respond correctly. If a mode doesn't work, recheck the switch wiring—loose crimps are the most common cause.
Light Bar Details
- 50" 390W RGB LED Light Bar for Can-Am Maverick X3 X3 Max R (2017–2026): Equipped with high-output 10W LEDs delivering up to 15,500 lumens, with clear PC lenses and a 6° spot beam combined with a 60° flood beam. This beam pattern gives you both long-distance focus and wide, even illumination, so you can see far down the trail and also light up the immediate sides for safer night driving.
50" 390W RGB LED Light Bar for Can-Am Maverick X3 X3 Max R (2017–2026)
