How to Install a Rear Camera on a Kawasaki Teryx KRX 1000
By Kemimoto Official: Aftermarket UTV Accessories & Parts | Published: 2026-10-19
Category: How-to Guides
Learn how to install a wired rear camera on your Kawasaki Teryx KRX 1000 with our step-by-step guide, including wiring tips and common mistakes to avoid.
Quick Answer
Install a plug-and-play wired rear camera on your Kawasaki Teryx KRX 1000 by mounting the camera, routing the cable, tapping into the reverse light for power, and connecting the display. The KEMIMOTO Plug and Play Wired Rear Camera is designed for a straightforward installation with minimal wiring.
Why a Wired Rear Camera Beats Wireless on a KRX 1000
Wired rear cameras offer a more reliable connection than wireless models, which can suffer from interference in off-road environments. On a Kawasaki Teryx KRX 1000, the cab and roll cage can block wireless signals, leading to lag or dropped video. A wired setup ensures a stable feed every time you shift into reverse.
Choosing the Right Mounting Location
Mount the camera high on the rear roll cage or on the rear fender to get a clear view of what's behind you. Avoid spots where mud or debris can easily cover the lens. The 170-degree ultra-wide angle lens on the KEMIMOTO camera helps you see blind spots your mirrors can't, but placement still matters for the best view.
Installation Steps
- Mount the camera: Secure the camera to the rear roll cage or fender using the included bracket and hardware. Position it so the lens has an unobstructed view of the area behind the UTV. Check that the camera is level and not tilted too far down or up before tightening.
- Route the video cable: Run the video cable from the camera along the roll cage and frame toward the front of the UTV, tucking it under plastic panels or using zip ties to keep it secure. Avoid pinching the cable under sharp edges or moving suspension parts.
- Connect power to the reverse light: Locate the reverse light wire near the tail light. Use a tap or splice to connect the camera's power wire to the reverse light circuit. Connect the ground wire to a clean chassis bolt. Test the connection with a multimeter to confirm the wire is only powered when in reverse.
- Mount the display and connect it: Mount the display on the dash or handlebar with the provided mount. Plug the video cable and power adapter into the display, then route the power to a keyed ignition source. Secure all cables with zip ties and avoid routing near hot engine parts.
- Test the system: Turn the ignition on, shift into reverse, and check that the display shows a clear image. Adjust the camera angle if the view is not centered. If the image is not clear, check the cable connections and ensure the camera lens is clean.
Product Spotlight
- Plug and Play Wired Rear Camera for Kawasaki Teryx KRX 1000: This camera features a 170-degree ultra-wide angle lens to minimize blind spots and a 480P sensor with night vision for clearer images in low light. The wide angle helps you see more of what's behind you, and the night vision ensures you can still reverse safely after sunset.
Plug and Play Wired Rear Camera for Kawasaki Teryx KRX 1000
After installation, take a short test drive to ensure the camera stays secure and the image remains stable. If you encounter any issues, double-check the wiring connections and cable routing.
